Televising
Televising, or televised inspection, uses specialized cameras to inspect the interior of sewer and stormwater lines.
- Routine assessments
- Pre-acceptance reports for new servers
- Identifying and locating problem areas
- Lateral inspection with a push camera up to 200 LF
Jet-Vac Cleaning
The Jet-Vac is used in large pipes such as sewer mains and storm sewers which have become clogged. The high-pressure water breaks up the debris while the vacuum draws it into the holding tank, leaving a clean pipe without washing the debris further down the line. It can also be used for cleaning exterior hard surfaces.
- Routine cleaning and maintenance of sewer mains and storm sewers
- 600 ft. of cleaning length vacuum liquid and other debris
- 2500 PSI of scouring pressure
- Cleaning gun for scouring manholes and lift stations
Open Cut
Open cut refers to the traditional method of excavation where an open trench is dug to install, repair, or replace pipe lines.
- Watermain and sewer pipe lines
- New and replacement
Lift Stations
Lift Stations are needed for moving wastewater from lower to higher elevations.
- Installation of new lift stations
- Replacement and repairing of existing lift stations
Repairing Sewer and Water Main Breaks
Kemper Construction Co. is your #1 choice for municipal water line repair.
- Sewer by-pass pumping – 6 inch pump
- Allowing the service to stay intact until repairs are complete
Pipe Bursting
Pipe bursting is a trenchless method to replace municipal pipes without excavation. It involves pulling a splitter head through the existing deteriorated pipe, splitting it, and pulling in a new pipe. Kemper Construction has been a pioneer in this method of pipe replacement in the Upper Midwest since 2004.
- Up to 80% less surface restoration – a big cost saving
- Much less disruption: less impact on residents and traffic
- Surface restoration is quicker because there is less to restore
- In areas of poor soils, less imported backfill and wear on city streets by heavy trucking
- Fused pipe is restrained with fewer joints and less chance of leakage
Is pipe bursting the right method for you?
Please contact us and we will help you evaluate your existing pipelines to see if they are a candidate for this method of pipe replacement.